New Dometic Replacement Cooling Units
If your RV refrigerator isn’t keeping your food fresh, rv ac units it’s time to replace the cooling unit. You can choose from a variety of options including gas absorption units, compressor refrigerators that run off battery power or solar energy, and even self-contained units.
The first step is to determine if you’re going to replace the entire cooling unit, or just part of it. The best way to do this is to take a good look at the unit. You can do this through the vent door on the side of your RV or by taking a look at the bottom of your refrigerator.
Often, you’ll see screws that are holding the unit in place at these locations. These can fall out or come loose, so you’ll want to use Blue Loctite Threadlocker when reinstalling them.
A leaking RV cooling unit can be a huge headache, but it’s usually not as complicated as you think. The most common problem is a failure in the refrigeration control board. This can cause your fridge to be unable to properly charge the refrigerant.
To avoid this, check the control board first. If it’s faulty, you can replace it for less money than replacing the entire fridge.
Once the control board is replaced, you’ll be able to see how much the refrigerator is cooling and if it’s getting hot. This can help you figure out if it’s the cooling unit that isn’t working correctly or if it’s something else that needs to be fixed.
When installing the new cooling unit, it’s important to follow the manufacturer’s installation instructions carefully. This is especially true if you’re replacing the evaporator foam pack that covers the inner coils of the cooling unit.
Before installing the evaporator foam pack, apply a layer of evaporator sealing tape around the outer edge of the foam. You can also use a Thermo-Mastic sealant to protect the new foam. Then you can insert the evaporator foam pack into the freezer compartment of the refrigerator and screw in the freezer and fin screws.
It is best to do a dry-run with the evaporator foam pack in place to ensure everything fits properly. This is an important step for any type of refrigerator repair, so it’s essential to do before you begin the actual installation.
Then you can install the new cooling unit and run it for a week to allow the fluids to fully mix and become fully charged. This will give you a chance to test it out to make sure that it’s functioning properly before you turn your RV on to use it.
If you’re looking for a new Dometic replacement cooling unit, consider purchasing one from a reputable remanufacturer. The remanufactured Nordic Cooling Units are an excellent option because they’re manufactured to the highest standards by professional technicians. They’re also significantly less expensive than replacing the entire RV refrigerator.